7 Step Led Gauge for Water Tank applications.
\n
\nEuropean Specification only
\n
\n
\n
\n
\nWIRING INSTRUCTIONS (Wiring diagram is included with the product or can be downloaded from the Document Section above.
\n-
\n
- Water Tank level \n
- 52mm diameter gauge \n
- 8 bright LEDs \n
- 12v/24v \n
- 0-190 ohms \n
- Only available, as standard, with black face & black bezel (options available for orders greater than 25 units) \n
- Red LED's will flash when water tank is empty \n
- Works with S3 senders of all lengths \n
\n
\n
\n
\n
\n
\nBlack - to sensor
\nRed - to positive (+)
\nBlue - to ground (-)
\nYellow - Red LEDs flashing On/Off - Earth to stop flashing.
\n
\n
\n
\nINSTALLATION INSTRUCTIONS
\n
\n
\n
\n
\n1. Cut a 52mm (2 1/16") diameter hole in the panel.
\n
\n
\n
\n
\nYou will need a minimum clearance of 55mm (2 3/16") behind the panel to fit the gauge.
\n2. Remove fastening ring and insert gauge through panel from the front, fit and tighten fastening ring from the rear.
\n3. Connect wires according to wiring diagram.
\n4. If you would like the Red LEDs to flash then do not connect the yellow wire.
\n
\nIf you would like the Red LEDs to remain on without flashing then connect the yellow wire to earth,
\n
\n
\n
\n
\n
\n
\n
\n* Note the use of dropping resistors for 24V circuit.
\n5. Insert wire harness into port at the back of the gauge.
\n
\n
\n